=========> Flight Link Control Center REQUIRES Microsoft .NET Framework 2.0 AND FSX SimConnect (sp2) <=========

To start installation run "setup.exe."

Note: F.C.C. v.4.1.1 requires SimConnect to be installed on your PC; if you have Microsoft FSX on your system then SimConnect is already installed (FSX service pack 2).

if don't have, or do not want, FSX on your PC you will still need to install SimConnect client which should download automatically with this installation; run "SimConnect.msi" then let it finish installing; you will have to re start "setup.exe" to complete the FCC installation.

=================================================================================================
-->FOR XPLANE VERSION 9.X:
From X-Plane click "Settings" and "Data Input & Output" then click on the “Data Set” tab. Select the "Internet
via UDP" bubble (left most bubble) for the following items:
00 frame rate
Close “Data Input & Output.”
Next click the “Settings” and “Net Connections” then click on the "Inet 3" tab. Select the "IP of data receiver (from data output screen)" bubble.
Enter 127.0.0.222 in the left most box. Next enter "49999" into the box to the right of where you entered the IP address.
______________________________________________________________________________________________________________

OR

-->FOR PREVIOUS VERSIONS OF XPLANE:
From X-Plane click "Settings" and "Data Input & Output". Select the "Internet
via UDP" bubble (left most bubble) for the following items:

00 frame rate, time ratio

Next click the "Inet 2" tab. Select the "IP Address of Data Receiver" bubble.
Enter 127.0.0.222 in the left most box. Next enter "49999" into the box right
of where you entered the IP address.

==================================================================================================

-->NOTE: for all versions of XPlane and FSX if you have a firewall installed on your system you will have to allow FCC.exe access through it to the internet.